Overview
How to plunge a drain, replace a toilet flapper, shut off water to a fixture, and fix a dripping faucet. These four skills save hundreds of dollars in plumber visits.
Step-by-Step Guide
Learn how to shut off water at three levels
Every homeowner must know three shutoff locations: (1) the main water shutoff for the whole house (typically near the water meter or where the main line enters the house), (2) individual fixture shutoff valves under sinks and behind toilets, and (3) the water heater shutoff. Practice turning each one off and on. Label them clearly.
Master the plunger technique
For toilets, use a flange plunger (the one with an extended rubber flap). Place it over the drain hole and push down slowly to create a seal — do not splash. Then pump firmly 10–15 times before pulling up sharply to break the clog. For sinks, use a flat cup plunger and cover the overflow hole with a wet rag to maintain suction.
Replace a toilet flapper
If the toilet runs constantly or periodically, the flapper is likely worn. Turn off the water at the shutoff valve behind the toilet. Flush to empty the tank. Unhook the old flapper from the overflow tube and disconnect the chain from the flush handle arm. Hook the new flapper on, reconnect the chain with about half an inch of slack, and turn the water back on.
Fix a dripping faucet
Most dripping faucets need a new cartridge or O-ring. Turn off the water supply under the sink. Remove the faucet handle (usually a hidden set screw under a decorative cap). Pull out the cartridge or valve stem. Take it to the hardware store to find an exact match. Install the replacement, reassemble, and turn the water back on.
Learn to clear a slow drain without chemicals
Remove the drain stopper or cover. Use a drain snake (also called a drum auger) by feeding the cable into the drain and turning the handle to advance it through the clog. Alternatively, remove the P-trap under the sink (place a bucket underneath first) and clean it out. Chemical drain cleaners damage pipes over time — avoid them.
Know how to stop an active leak temporarily
For a pinhole pipe leak, turn off the water supply and apply a pipe repair clamp or wrap with self-fusing silicone tape as a temporary fix. For a leaking supply line connection, try hand-tightening the compression fitting. For a leaking shut-off valve, place a bucket and towels and call a plumber. These are temporary measures — permanent repairs need proper fittings.
Understand when you are in over your head
Basic plumbing skills cover drips, clogs, and running toilets. Stop and call a plumber for: anything behind walls or under floors, main sewer line issues, water heater problems, frozen or burst pipes, gas water heater pilot lights, and any repair that requires soldering copper pipe.
What You'll Need
Tools
- - Flange plunger (for toilets)
- - Cup plunger (for sinks)
- - Adjustable wrench
- - Channel-lock pliers
- - Drain snake (drum auger)
- - Bucket
- - Plumber's tape (Teflon tape)
- - Flashlight
Materials
- - Replacement toilet flapper (universal fit)
- - Assorted faucet O-rings and washers
- - Plumber's tape (Teflon tape)
- - Pipe repair clamp (for emergencies)
- - Self-fusing silicone tape (for emergency pipe wraps)
Cost Estimates
DIY Cost
$5–$20 per repair (flapper, O-ring, or plumber's tape)
Professional Cost
$100–$300 per visit (plumber for basic repairs)
Safety Tips
- Always turn off the water supply before disassembling any plumbing fixture.
- Place a towel or bucket under connections before loosening them — residual water will drain out.
- Never use excessive force on old shutoff valves — corroded valves can break, causing a flood. If a valve is stuck, call a plumber.
- Avoid chemical drain cleaners — they corrode pipes, harm the environment, and are dangerous if they splash.
When to Call a Professional
Call a plumber for any leak inside a wall or under a floor, main sewer line backups, water heater issues, frozen or burst pipes, gas line connections, and any plumbing that requires a permit (such as adding or relocating a fixture).
Pro Tip
Keep a universal toilet repair kit under each bathroom sink. A $10 kit contains a flapper, fill valve, and supply line — the three parts that cause 95% of toilet problems. When one fails at midnight, you will have the fix on hand.
Common Mistakes to Avoid
- Not knowing where the main water shutoff is before an emergency — locate it on day one.
- Overtightening plumbing connections and cracking plastic fittings or stripping threads.
- Using chemical drain cleaners instead of a plunger or snake — chemicals corrode pipes and create worse problems.
- Forgetting to turn off the water before working on a fixture and getting sprayed.
- Trying to fix a leak behind a wall without professional help — hidden plumbing mistakes cause thousands in water damage.
Local Plumbers in Renton

Bellevue Plumbing
Bellevue, WA
(425) 641-4222
Mikes Plumbing Tacoma
Tacoma, WA
(253) 740-3248Clog Flow Plumbers of Redmond
Bellevue, WA
(425) 428-5246Founding Member
Premium spot in Renton
Ambassador
Lead the Renton community
Founding Member
Premium spot in Renton
Renton Housing Market
Median Home Price
$824,900
Homes for Sale
138
Price per Sq Ft
$430
Local Pros
560
Home Service Professionals Near Renton
Median Household Income
$96,626
Median Home Value
$631,400
Median Rent
$1,923/mo
Homeownership Rate
54.9%
Population
105,279
Median Year Built
1989
Source: U.S. Census Bureau, ACS 2023 5-Year Estimates
Fair Market Rents — Renton
Studio
$2,074/mo
1 Bedroom
$2,146/mo
2 Bedroom
$2,501/mo
3 Bedroom
$3,272/mo
4 Bedroom
$3,847/mo
Source: HUD FY2026 Fair Market Rents — Seattle-Bellevue, WA HUD Metro FMR Area
This Task Appears On
Related How-To Guides
Check for Signs of Water Damage
Inspect under sinks, around windows, in the basement or crawl space, and attic for water stains or mold. Catching water damage early prevents costly structural repairs.
Build a Basic Home Tool Kit
Hammer, screwdrivers, pliers, adjustable wrench, tape measure, level, drill, stud finder, flashlight. Every homeowner needs a solid toolkit for basic repairs and projects.
Know When to Call a Professional
Electrical work, gas lines, structural issues, roof work, and anything involving permits — always hire a pro. Knowing your limits is one of the most valuable homeowner skills.

